Files
esp-nimble/nimble/drivers/dialog_cmac/syscfg.yml
Andrzej KaczmarekandWill San Filippo e69a66d715 nimble/phy: Add PHY for Dialog CMAC
This adds PHY for Dialog CMAC.

This allows to run complete NimBLE controller on Dialog DA1469x MCU
family. 1M and 2M PHYs are supported, Coded support is missing in
hardware at the moment.

Some parts of code that access RF block are obfuscated, but there
are no proprietary binaries used so fixes are possible if necessary.

Co-authored-by: Will San Filippo <[email protected]>
2020-09-21 13:53:51 +02:00

30 lines
1.1 KiB
YAML

# Licensed to the Apache Software Foundation (ASF) under one
# or more contributor license agreements. See the NOTICE file
# distributed with this work for additional information
# regarding copyright ownership. The ASF licenses this file
# to you under the Apache License, Version 2.0 (the
# "License"); you may not use this file except in compliance
# with the License. You may obtain a copy of the License at
#
# http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing,
# software distributed under the License is distributed on an
# "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY
# KIND, either express or implied. See the License for the
# specific language governing permissions and limitations
# under the License.
#
syscfg.defs:
BLE_PHY_RF_HP_MODE:
description: Enable high-performance RF mode.
value: 1
BLE_PHY_DEBUG_DSER:
description: Enable DSER output from PHY
value: 0
syscfg.restrictions:
- BLE_LL_RFMGMT_ENABLE_TIME == 0 || BLE_LL_RFMGMT_ENABLE_TIME >= 20