mirror of
https://github.com/espressif/esp-nimble.git
synced 2026-08-12 04:57:55 +00:00
Łukasz Rymanowski
1a57236fde
This patch adds initial support for enhanced LE CoC. For now we allow for MTU reconfiguration as it bilongs to the application. We do not allow for MPS reconfiguration, as it is assumed that MPS is always used the biggest possible. However that might change as we start PTS testing. Some of the initial verification has been done with PTS To enable feture BLE_L2CAP_ENHANCED_COC shall be enabled along with BLE_VERSION >= 52 and non zero BLE_L2CAP_COC_MAX_NUM
Apache Mynewt NimBLE
Overview
See (https://mynewt.apache.org/network/ble/ble_intro/).
Building
NimBLE is usually built as a part of Apache Mynewt OS, but ports for other RTOS-es are also available.
Linux
- Build the sample application
cd porting/examples/linux
make
- Run the sample application
First insert a USB Bluetooth dongle. These are typically BLE 4.0 capable.
Verify the dongle is connected with hciconfig:
$ hciconfig
hci0: Type: BR/EDR Bus: USB
BD Address: 00:1B:DC:06:62:5E ACL MTU: 310:10 SCO MTU: 64:8
DOWN
RX bytes:5470 acl:0 sco:0 events:40 errors:0
TX bytes:5537 acl:176 sco:0 commands:139 errors:1
Then run the application built in step one. The application is configured in sysconfig.h to use hci0.
cd porting/examples/linux
sudo ./_build/nimble_linux.out
- Build and run the unit tests
The Operating System Abstraction Layer (OSAL) used to port Nimble to Linux has a suite of unit tests.
cd tests/unit/porting/npl
make test